반응형
Q>
Default-Gateway를 설정하고 저장하시오.
A>
Router>enable
Router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#do sh ip int b
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 unassigned YES unset administratively down down
FastEthernet1/0 unassigned YES unset administratively down down
Serial2/0 unassigned YES unset administratively down down
Serial3/0 unassigned YES unset administratively down down
FastEthernet4/0 unassigned YES unset administratively down down
FastEthernet5/0 unassigned YES unset administratively down down
Router(config)#ip default-network 192.168.0.10
Router(config)#do sh ip int b
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 unassigned YES unset administratively down down
FastEthernet1/0 unassigned YES unset administratively down down
Serial2/0 unassigned YES unset administratively down down
Serial3/0 unassigned YES unset administratively down down
FastEthernet4/0 unassigned YES unset administratively down down
FastEthernet5/0 unassigned YES unset administratively down down
Router(config)#do sh ip route
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
* - candidate default, U - per-user static route, o - ODR
P - periodic downloaded static route
Gateway of last resort is not set
Router(config)#exi
Router#
%SYS-5-CONFIG_I: Configured from console by console
Router#
Router#copy running-config startup-config
Destination filename [startup-config]?
Building configuration...
[OK]
Router#
반응형
'Network' 카테고리의 다른 글
[네트워크관리사]Router Quiz 13 (0) | 2021.09.02 |
---|---|
[네트워크관리사]Router Quiz 12 (0) | 2021.09.02 |
[네트워크관리사]Router Quiz 10 (0) | 2021.09.01 |
[네트워크관리사]Router Quiz 9 (0) | 2021.09.01 |
[네트워크관리사]Router Quiz 8 (0) | 2021.09.01 |