[네트워크관리사]Router Quiz 9

Q>

FastEthernet 0/0의 description을 설정하고 NVRAM에 저장하시오.

 

A>

Router>enable 
Router#configure terminal 
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#
Router(config)#do sh ip int b
Interface              IP-Address      OK? Method Status                Protocol 
FastEthernet0/0        unassigned      YES unset  administratively down down 
FastEthernet1/0        unassigned      YES unset  administratively down down 
Serial2/0              unassigned      YES unset  administratively down down 
Serial3/0              unassigned      YES unset  administratively down down 
FastEthernet4/0        unassigned      YES unset  administratively down down 
FastEthernet5/0        unassigned      YES unset  administratively down down
Router(config)#interface FastEthernet 0/0
Router(config-if)#description CISCO
Router(config-if)#exi
Router(config)#do sh ip int b
Interface              IP-Address      OK? Method Status                Protocol 
FastEthernet0/0        unassigned      YES unset  administratively down down 
FastEthernet1/0        unassigned      YES unset  administratively down down 
Serial2/0              unassigned      YES unset  administratively down down 
Serial3/0              unassigned      YES unset  administratively down down 
FastEthernet4/0        unassigned      YES unset  administratively down down 
FastEthernet5/0        unassigned      YES unset  administratively down down
Router(config)#exi
Router#
%SYS-5-CONFIG_I: Configured from console by console

Router#copy running-config startup-config 
Destination filename [startup-config]? 
Building configuration...
[OK]
Router#